[ROM] Erste CM 14.1-Nightly fürs OP 3

[CM-Psycho]

(23.11.2016, 23:49)sluter schrieb: Kann man mit der TWRP 3.0.2-22 auch ein CM13-Backup wieder einspielen?
Ich hatte per TWRP alles gesichert (ausser Cache). Nach einem Restore startet zwar das OP3, aber ich bekomme bei der ersten PIN-Eingabe (Verschlüsselung) keine Tastatur angezeigt - komme also nicht mehr weiter.

Sollte gehen ..... Und wenn nicht dann mal ein altes recovery Flashen ....

Vor und nach restore auch mal wipe cache und davlik gemacht ?

Gesendet von meinem A0001 mit Tapatalk

[sluter]

(23.11.2016, 23:54)CM-Psycho schrieb: Sollte gehen ..... Und wenn nicht dann mal ein altes recovery Flashen ....

Vor und nach restore auch mal wipe cache und davlik gemacht ?

Leider kann man (ich) das alte Recovery nicht mehr einspielen. Also flash geht noch, aber das OP3 startet nicht mehr ins TWRP.
Wenn ich das 3.0.2-22 wieder drauf mache, startet TWRP wieder, aber das PAssword-Problem bleibt.  
Selbst mit ein komplettes Restore mit allem: "Boot, Data, Recovery, System, System Image, EFS" bringt kein Erfolg.

[daywalk3r666]

https://android-hubo.de/thread/4589-onep...post100718

das sollte dein problem lösen.

[Jester]

Die Nightly von heute hat endlich das Akku-Design was man vermissen könnte (ich habe meine runde Akkuanzeige schon vermisst sei CM 13). Auch neue Bootanimation, usw. Das Changelog ist mal wieder prall gefüllt:

Zitat:Settings: Add CMHW vibrator intensity preference (android_packages_apps_Settings)
cm: Revert the new boot animation generation process (android_vendor_cm)
bugreport: Stop crashing when packages change (android_packages_apps_CMBugreport)
dex2oat: Use CLOCK_MONOTONIC, not REALTIME for a watchdog! (android_art)
cmhw: Account for devices that don't use manager0 sysfs paths (android_hardware_ti_omap4)
VibratorService: Track vibrator intensity (android_frameworks_base)
PhoneWindowManager: Implement press home to answer call (android_frameworks_base)
am: Account for time changes when showing recent activities (android_frameworks_base)
cmsdk: Define a default LED capabilities value (cm_platform_sdk)
oneplus3: Switch to the unified LED capabilities overlay (android_device_oneplus_oneplus3)
CMParts: Use NotificationManager to figure out LED capabilities (android_packages_apps_CMParts)
UnifiedEmail: Use NotificationManager to figure out LED capabilities (android_packages_apps_UnifiedEmail)
Email: Use NotificationManager to figure out LED capabilities (android_packages_apps_Email)
cmsdk: Switch to a unified LED capabilities overlay (cm_platform_sdk)
NotificationManager: Concentrate LED light capabilities in a single location (android_frameworks_base)
op3: sepolicy: Update for N (android_device_oneplus_oneplus3)
libhwc: Ensure buffer type is a v4l2_buf_type (android_hardware_samsung_slsi_exynos5)
gralloc: Move rgb/yuv format handling to header (android_hardware_samsung_slsi_exynos5)
roomservice: Follow fetched android_device_ projects (android_vendor_cm)
ColorFade: fix EGL crash on exynos4 mali blobs (android_frameworks_base)
bootanim: Use a for loop to make part# folders (android_vendor_cm)
Derp (android_device_oneplus_oneplus3)
op3: Correct hash of org.ifaa.android.manager.jar (android_device_oneplus_oneplus3)
SystemUI: Add VectorDrawable battery styles (android_frameworks_base)
Fix wrong bootanimation.zip from mkdir .../part{0..2} (android_vendor_cm)
Tethering: Turn off wifi hotspot after inactivity(3/3) (android_packages_apps_Settings)
Tethering: Turn off wifi hotspot after inactivity(2/3) (android_frameworks_opt_net_wifi)
Tethering: Turn off wifi hotspot after inactivity(1/3) (android_frameworks_base)
cm: Build bootanimation.zip (android_vendor_cm)
Revert "Add PRODUCT_BOOTANIMATION" (android_build)
cm: Rework boot animation generation (android_vendor_cm)
Settings: Use GLIF Theme for missing Settings > Screen lock Activities (android_packages_apps_Settings)
op3: Make qcacld driver a module (android_device_oneplus_oneplus3)
op3: Add vendor changes to wifi configuration (android_device_oneplus_oneplus3)
op3: Add wifi configuration from LA.UM.5.5.r1-01600-8x96.0 (android_device_oneplus_oneplus3)
wcnss: Remove dump of SAW2 registers (android_kernel_oneplus_msm8996)
wcnss: Access A2xb split timeout limit register for titanium (android_kernel_oneplus_msm8996)
net: cnss_prealloc: Add memory for high latency SDIO interface (android_kernel_oneplus_msm8996)
net: cnss: refactor PM QoS request wrapper API (android_kernel_oneplus_msm8996)
cnss_prealloc: Dump the call stack if there is no memory available (android_kernel_oneplus_msm8996)
cnss: Expose dump stack functionality (android_kernel_oneplus_msm8996)
net: cnss: add unsafe channel list support for dual WiFi (android_kernel_oneplus_msm8996)
net: cnss: add DFS NOL support for dual WiFi (android_kernel_oneplus_msm8996)
net: cnss: add PM QoS support for dual WiFi (android_kernel_oneplus_msm8996)
net: cnss: add subsystem restart support for dual WiFi (android_kernel_oneplus_msm8996)
cnss: Implement API to store WLAN MAC address in platform driver (android_kernel_oneplus_msm8996)
wcnss: Access boot remap address register (android_kernel_oneplus_msm8996)
net: cnss: add cnss common api support for dual WiFi (android_kernel_oneplus_msm8996)
cnss: Add Pinctrl Framework to control antenna sharing GPIO 38 (android_kernel_oneplus_msm8996)
net: cnss: add bus bandwidth support for sdio wlan module (android_kernel_oneplus_msm8996)
cnss: Control vdd-wlan-xtal-aon-supply regulator in cnss platform driver (android_kernel_oneplus_msm8996)
Revert "cnss: Disable wlan irq when PCIe link down is detected" (android_kernel_oneplus_msm8996)
net: cnss: remove redundant and dead code from platform driver (android_kernel_oneplus_msm8996)
cnss: Add optional property to control wlan_en gpio for Dual-Wifi platforms (android_kernel_oneplus_msm8996)
Revert "net: cnss: remove redundant and dead code from platform driver" (android_kernel_oneplus_msm8996)
net: cnss: remove redundant and dead code from platform driver (android_kernel_oneplus_msm8996)
net: cnss: add dual cnss platform driver support for dual WiFi (android_kernel_oneplus_msm8996)
net: cnss: add CNSS logger service to support advanced CLD logging (android_kernel_oneplus_msm8996)
cnss: Refactor CNSS Platform Driver for better code maintenance (android_kernel_oneplus_msm8996)
cnss: Correct boot sequence for WLAN hardware (android_kernel_oneplus_msm8996)
net: cnss: Fix the NULL pointer dereference (android_kernel_oneplus_msm8996)
cnss: Expose Power Up/Down API to WLAN Functional Driver (android_kernel_oneplus_msm8996)
cnss: Disable wlan irq when PCIe link down is detected (android_kernel_oneplus_msm8996)
cnss: store the unsafe channel info even channel count is zero (android_kernel_oneplus_msm8996)
cnss: Provide API to CLD Driver to control SPDT GPIO (android_kernel_oneplus_msm8996)
net: CNSS: Define new config WLAN_FEATURE_RX_WAKELOCK (android_kernel_oneplus_msm8996)
cnss: disable pre-alloc memory leak check and reset for dual WiFi (android_kernel_oneplus_msm8996)
net: cnss_prealloc: add pre alloc support for socket buffer (android_kernel_oneplus_msm8996)
net: cnss_prealloc: Add prealloc memory for dual WiFi device (android_kernel_oneplus_msm8996)
wil6210: fix chan check in wil_p2p_listen (android_kernel_oneplus_msm8996)
wil6210: abort P2P search when stopping P2P device (android_kernel_oneplus_msm8996)
cnss: Initialize the unsafe channel list structure properly (android_kernel_oneplus_msm8996)
net: cnss_prealloc: add debugfs entry to check the memory status (android_kernel_oneplus_msm8996)
wcnss: Avoid user buffer overloading for write cal data (android_kernel_oneplus_msm8996)
cnss: Use Different Dump Names for QCA PCIe and SDIO targets (android_kernel_oneplus_msm8996)
net: cnss: Add support to get fw files for QCA SDIO target (android_kernel_oneplus_msm8996)
net: cnss: add fixed regulator support for wlan enable pin (android_kernel_oneplus_msm8996)
cnss: add support for pinctrl framework to configure the wlan gpio (android_kernel_oneplus_msm8996)
net: cnss: Release QCA Chip resources when Wi-Fi is turned off (android_kernel_oneplus_msm8996)
cnss: Reset QCA Card during WLAN SubSystem Recovery (android_kernel_oneplus_msm8996)
cnss: Toggle PCIe EP WLAN_EN on dual-wifi platforms (android_kernel_oneplus_msm8996)
Revert "cnss: Configure wlan gpio" (android_kernel_oneplus_msm8996)
cnss: Enable SECURE FIRMWARE Download Feature (android_kernel_oneplus_msm8996)
wcnss: Read multiple SMD Packet from SMD Channel (android_kernel_oneplus_msm8996)
cnss: Fix compilation error of missing CONFIG_CNSS_SECURE_FW (android_kernel_oneplus_msm8996)
qcacld-2.0: Release LA.UM.5.5.r1-01800-8x96.0 (android_kernel_oneplus_msm8996)
op3: Update defconfig for new qcacld driver (android_kernel_oneplus_msm8996)
ARM: dts: msm: add fixed regulator support for wlan_en for msm8996 (android_kernel_oneplus_msm8996)
ARM: dts: msm: Config sleep state for wlan bootstrap pin for msm8996 (android_kernel_oneplus_msm8996)

Und ja, das Rom geht einwandfrei. Dauert beim ersten Booten lange, nicht die geduld verlieren .

mfg